Alprojet - Suction Line Cleaner Get latest price

Read more...

To contact William Green about Alprojet Suction Line Cleaner use Get a quote.

Procedure for Applying AlproJet to Suction System;

Daily – AlproJet D

Mix 1 litre of AlproJet D as a 5% solution (50ml of AlproJet D to 950ml of warm water 40o), in a suitable container.

Lift both suction hoses from their holders, with the valves open and solids strainer in place; introduce the ends to the solution such that a mixture of air and solution is taken up. About 300ml should be drawn up, the hoses should then be returned to their holders and allowed to sit for 5 minutes. This process allows the AlproJet D to react with the protein coating within the interior of the hoses.

Repeat the process of drawing up 300ml of solution as described above allowing a further 5 minute soaking.

Draw up the remainder of the solution and allow to soak again for 5 minutes.

Finally, flush the system with clean water.

If more than one surgery is being processed, use the soaking time to dose the next unit.

This process should be performed on a Daily Basis.

Weekly – AlproJet W

AlproJet W is applied in the same manner as above but on a Weekly Basis, or more frequently there is a high protein build-up or foaming occurs. After completing the AlproJet W treatment, the suction hoses may be removed from the unit and left soaking in clean water until the next use.

Please note; This is a two part cleaning process, both the daily and weekly procedures must be followed to complete the decontamination process.

Read less...

To contact William Green about Alprojet Suction Line Cleaner use Get a quote.